Center It - A Tube Drilling Jig
Catalog Number: Price:
30274 $23.95 ea.
$84.95 for 5
$159.95 for 10
Center It is a tool for drilling pipe and other round objects. Center It is made specifically for use in a drill
press. The 7/16" groove with a 118 degree angle lets you bottom drill bit to center v-block. The 5 " long, 4" wide V-block bolts to the drill press table and enables the
drilling of round pieces parallel and centered. This allows you to drill any size of pipe and wood dowels. The grooves on the outer sides eliminate slippage while holding pipes, etc., for sawing on
job sites or other applications. To use, simply place Center It on the drill press table, run the bit down (with motor off) to hold the jig centered on the bit, then bolt the jig to
press table. No clamping of the tube is necessary since the angled flats of the jig hold it centered. Holes will automatically be centered on the tube with no center-punching
necessary. If tubing is too large to drill in a single operation it can simply be turned over. |
