MATERIAL SAFETY DATA SHEET
Product Name: DMP-30
Catalog Number: 21370
Other Names: 2,4,6-Tri(dimethylaminomethyl)phenol
DOT Hazard Class: Not Regulated
MSDS Updated: 9/2009
Distributed By: Ladd Research Industries
83 Holly Court
Williston, VT
05495
(802) 658-4961
HAZARDOUS
COMPONENTS
CAS Number Percent Exposure
Limits
DMP-30 90-72-2
89-98% None Established
Dimethylaminomethyl
phenol 25338-55-0 2-11% None Established
PHYSICAL AND
CHEMICAL DATA
Boiling Point: 316EC
Vapor Pressure:
<0.01 mm Hg at 21EC
Vapor Density: >1
(air = 1)
Specific Gravity:
0.973
Solubility: Slightly
soluble in water
Evaporation Rate:
<1 (butyl acetate = 1)
Appearance and Odor:
Amber to red-brown liquid. Ammonia
odor.
FIRE AND
EXPLOSION HAZARD DATA
Flash Point: 124EC (Cleveland Open Cup)
Explosive Limits:
Not Available
Extinguishing Media:
Carbon dioxide, dry chemical and/or water spray
Personal Protective
Equipment: Wear self-contained breathing apparatus and full protective gear.
HEALTH HAZARD
DATA
Primary Routes of
Entry: Inhalation, ingestion and skin/eye contact
Inhalation:
Irritation of nose, throat and lungs
Ingestion: Burning
and severe swelling of the mouth, throat and abdomen, nausea and vomiting.
Skin: Severe skin
irritation and burns
Eyes: Corrosion of
eyes. Permanent, irreversible eye
injury.
EMERGENCY AND
FIRST AID
Inhalation: Move
subject to fresh air. Give artificial
respiration if breathing has stopped.
Ingestion: DO NOT
induce vomiting. Neutralize by giving
milk or egg whites. Otherwise, wash
out mouth with water and
dilute by giving large quantities of water to drink.
Immediately see a physician.
Eye and Skin:
Immediate removal from the skin is essential to prevent serious injury. Flush eyes with water for at
least 15 minutes. Obtain prompt medical attention
REACTIVITY DATA
Stability: Stable at
ambient temperatures. Avoid temperature
extremes.
Hazardous
Polymerization: Will not occur.
Conditions to Avoid:
Excessive heat.
Incompatibility:
Strong oxidizing and reducing agents.
Hazardous
Decomposition Products: Oxides of nitrogen and carbon.
SPILL, DISPOSAL
AND STORAGE INFORMATION
Spill: Ventilate
area. Avoid breathing vapor. Evacuate spill area. Wear respirator. Dike and
contain spill with inert
material. Scoop material into container
for disposal.
Disposal: Incinerate
liquid and contaminated diking material at a permitted facility according to
federal, state and local
regulations.
Storage: Low
temperature storage can cause handling problems. Store indoors at room
temperature.
PROTECTIVE
EQUIPMENT AND CONTROL MEASURES
Respiratory: Wear
suitable respirator.
Gloves: Impervious
(e.g. nitrile, butyl rubber)
Eye: Chemical splash
goggles or face shield.
Ventilation:
Mechanical local exhaust ventilation at point of contaminant release
recommended.
SECTION 313
SUPPLIER NOTIFICATION
Not applicable.
(((((((((((((((((((((((((((((((((((((((((((((((((((((((((((
The information presented is believed to be correct and is the most accurate information available to us at this time. However, Ladd Research makes no warranty, express or implied, and assumes no liability for this information and the product described herein.