Water Purification & Detection, Light Tables, Lab Balances & More

Center It is a tool for drilling pipe and other round objects. Center It is made specifically for use in a drill press. The 7/16" groove with a 118 degree angle lets you bottom drill bit to center v-block. The 5 " long, 4" wide V-block bolts to the drill press table and enables the drilling of round pieces parallel and centered. This allows you to drill any size of pipe and wood dowels. The grooves on the outer sides eliminate slippage while holding pipes, etc., for sawing on job sites or other applications. To use, simply place Center It on the drill press table, run the bit down (with motor off) to hold the jig centered on the bit, then bolt the jig to press table. No clamping of the tube is necessary since the angled flats of the jig hold it centered. Holes will automatically be centered on the tube with no center-punching necessary. If tubing is too large to drill in a single operation it can simply be turned over. Learn More

• - 5 Speeds
• - 1/3 HP, 120 VAC, 60 Hz, Single Phase
• - 620, 1100, 1720, 2340 & 3100 rpm
• - 1/2" Drill Chuck Capacity
• - 2" Maximum Spindle Stroke
• - 6 3/4" Maximum Distance from Chuck to Table
• - 10" Maximum Distance from Chuck to Base
• - 9 1/2" Maximum Swing
• - 1.89" Column Diameter
• - 6 5/16" x 6 1/2" Table Size
• - 23" x 7" x 17" Overall Dimensions
• - 7" x 11 1/8" Base Size

Learn More

This unit will permit operation of the powerstat from a 220-230 volt, 50/60 Hz source. Learn More

This unit delivers 0-132 volts (2.0 amps maximum current) from a 120 volt, 50/60 Hz single phase source. Has toggle switch, fuse, 3-wire parallel blade input cord/plug set, and receptacle housed in a steel terminal enclosure. Learn More

To support still. Extra heavy stand plus clamps and ring. Learn More

For use with a 1000 ml flask. Learn More

Glass Receiving Flask. Learn More

Glass Column Condenser. Learn More

Kjeldahl Connecting Bulb. Learn More