Water Purification & Detection, Light Tables, Lab Balances & More

Outside dimensions: 17 3/4" high x 19 3/4" wide x 19 1/2" deep. Adjustable shelf. Magnetic door gasket. Adjustable thermostat. Hermetically sealed copressor. UL approved. Small freezer compartment. Operates on 115 VAC.

Used with L03090 or L03067 and clamps the small pyrex rods into the L590. The clamp is anodized aluminum and squeezes against the pyrex rod, holding it in place. Included at no charge with the purchase of the BiPod Polisher.

A round stainless steel disc. This assembly is mounted to the base of the Tripod Polisher and is primarily used for plan parallel polishing of specimens. 1.25" Diameter

Viewing Box - 36" x 48" overall size. Contains five 18 watt bulbs.

Base with 3 micrometer assemblies and case.

This free-standing magnifier allows enhanced viewing of Petri dishes, multi-well plates, x-ray films, stained gels, slides or text. The precision molded lens offers 1.75 x magnification. The unique stand allows the magnifier to be placed over a variety of objects, including the Mini Light Box (sku: 81016).

This bracket has a set screw on each side of the bracket which is designed to hold an SEM mount in place.

Center It is a tool for drilling pipe and other round objects. Center It is made specifically for use in a drill press. The 7/16" groove with a 118 degree angle lets you bottom drill bit to center v-block. The 5 " long, 4" wide V-block bolts to the drill press table and enables the drilling of round pieces parallel and centered. This allows you to drill any size of pipe and wood dowels. The grooves on the outer sides eliminate slippage while holding pipes, etc., for sawing on job sites or other applications. To use, simply place Center It on the drill press table, run the bit down (with motor off) to hold the jig centered on the bit, then bolt the jig to press table. No clamping of the tube is necessary since the angled flats of the jig hold it centered. Holes will automatically be centered on the tube with no center-punching necessary. If tubing is too large to drill in a single operation it can simply be turned over.

This unit delivers 0-132 volts (2.0 amps maximum current) from a 120 volt, 50/60 Hz single phase source. Has toggle switch, fuse, 3-wire parallel blade input cord/plug set, and receptacle housed in a steel terminal enclosure.

Glass Receiving Flask.