Water Purification & Detection, Light Tables, Lab Balances & More

Outside dimensions: 17 3/4" high x 19 3/4" wide x 19 1/2" deep. Adjustable shelf. Magnetic door gasket. Adjustable thermostat. Hermetically sealed copressor. UL approved. Small freezer compartment. Operates on 115 VAC. Learn More

This insert is a glass stub used for TEM polishing of specimens. It is used in conjunction with the slotted L bracket and is used for wedge polishing applications. Not included with the purchase of the BiPod Polisher. Learn More

Similar in function to the Pyrex insert. Specimens are mounted to the rod for wedge polishing applications. Included at no charge with the purchase of the BiPod Polisher. Learn More

Used with L03090 or L03067 and clamps the small pyrex rods into the L590. The clamp is anodized aluminum and squeezes against the pyrex rod, holding it in place. Included at no charge with the purchase of the BiPod Polisher. Learn More

The Tripod Polisher, L590TS, comes complete with sufficient accessories to prepare samples for both scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The following accessories are included at no charge with the purchase of the L590TS. (prices are included if you wish to purchase additional accessories) Learn More

Vibrasorb Damping Mounts isolate sensitive analytical balances and other instruments from vibrations caused by nearby equipment such as pumps, stirrers and blenders. Molded of dense black and white terrazzo, this 2 1/2" thick platform is supported on four Vibro-Absorber cushions and neoprene feet and support up to 35 pounds. This unit will absorb vibrations down to 13Hz with a 35 pound load. With lighter loads, the minimum frequency of damping will increase to a value between 16Hz and 25Hz. A polished surface resists scratches and chemical attack. 18" x 22". Shipping weight - 87 lbs. Learn More

A round stainless steel disc. This assembly is mounted to the base of the Tripod Polisher and is primarily used for plan parallel polishing of specimens. 1.25" Diameter Learn More

Designed to accept the special SEM stud used with the Tripod Polisher. The SEM stud is mounted in the Ion Mill Stage and sample is briefly ion milled to remove fine scratches, polishing debris and to give surface topography prior to SEM analysis. Learn More

For leveling the L590TS. Learn More