Water Purification & Detection, Light Tables, Lab Balances & More

The Tripod Polisher, L590TEM, comes complete with sufficient accessories to prepare samples for transmission electron microscopy (TEM). The following accessories are included at no charge with the purchase of the L590TEM. (prices are included if you wish to purchase additional accessories) Learn More

5 inch diameter ophthalmic magnifying lens provides a large viewing area with no distortion. Improves visual acuity with its 2X magnification and direct light source. Leaves both hands free for working or handling small tools. Learn More

This free-standing magnifier allows enhanced viewing of Petri dishes, multi-well plates, x-ray films, stained gels, slides or text. The precision molded lens offers 1.75 x magnification. The unique stand allows the magnifier to be placed over a variety of objects, including the Mini Light Box (sku: 81016). Learn More

Similar in function to the Pyrex insert. Specimens are mounted to the rod for wedge polishing applications. Included at no charge with the purchase of the BiPod Polisher. Learn More

Used with L03090 or L03067 and clamps the small pyrex rods into the L590. The clamp is anodized aluminum and squeezes against the pyrex rod, holding it in place. Included at no charge with the purchase of the BiPod Polisher. Learn More

This bracket has a set screw on each side of the bracket which is designed to hold an SEM mount in place. Learn More

For general use in the laboratory. 2 1/2" long x 1/2" deep jaws. Tilts, turns and rotates with a quick turn of the control know. Vacuum base holds the vise firmly to any surface. Includes standard head and smooth, nylon jaws. Learn More

Center It is a tool for drilling pipe and other round objects. Center It is made specifically for use in a drill press. The 7/16" groove with a 118 degree angle lets you bottom drill bit to center v-block. The 5 " long, 4" wide V-block bolts to the drill press table and enables the drilling of round pieces parallel and centered. This allows you to drill any size of pipe and wood dowels. The grooves on the outer sides eliminate slippage while holding pipes, etc., for sawing on job sites or other applications. To use, simply place Center It on the drill press table, run the bit down (with motor off) to hold the jig centered on the bit, then bolt the jig to press table. No clamping of the tube is necessary since the angled flats of the jig hold it centered. Holes will automatically be centered on the tube with no center-punching necessary. If tubing is too large to drill in a single operation it can simply be turned over. Learn More

• - 5 Speeds
• - 1/3 HP, 120 VAC, 60 Hz, Single Phase
• - 620, 1100, 1720, 2340 & 3100 rpm
• - 1/2" Drill Chuck Capacity
• - 2" Maximum Spindle Stroke
• - 6 3/4" Maximum Distance from Chuck to Table
• - 10" Maximum Distance from Chuck to Base
• - 9 1/2" Maximum Swing
• - 1.89" Column Diameter
• - 6 5/16" x 6 1/2" Table Size
• - 23" x 7" x 17" Overall Dimensions
• - 7" x 11 1/8" Base Size

Learn More