Laboratory Supplies - Disposables, Storage, Safety Aids & More

Designed for quick, easy polymerization of both plastic embedding media and plastic mounting media. Specimen tray designed to hold up to 12, 3" x 1" glass slides. Ultraviolet peak radiation is 320-360 nm, so presents minimal hazard to user. Can be operated at temperatures as low as 0o C for heat sensitive specimens. Unit is compact and lightweight with external dimensions of 5 1/4" high x 5 1/2" deep x 19" wide. Has hinged top for easy access to specimen tray. Operates on 110-120 VAC, 60 Hz at less than 1 amp. Step-down transformer available for 220-240 VAC, 50-60 Hz. Replacement lamps available . Capsule holder included.

Set of 75 straight side glass vials with flat bottoms and black plastic screw caps. Each bottle has a volume of 2 drams, is 17 mm diameter x 60 mm high.

Designed specifically for wedge polishing of TEM specimens. the mount consists of a small aluminum clamping mechanism and 5 Pyrex rods which slide into the center of the clamp and are held in place when the L-bracket is tightened. Not included with the purchase of the BiPod Polisher.

Our new mini-centrifuge is the perfect answer for quick spin-downs from tubewalls and caps, HPLC preparations, cell separations and micro-filtration tubes. The tiny footprint and quiet operation makes it perfect for desktop use or quick transport between countertops. A great convenience and a superb value!

Specifications:

• rpm: 6,000
• Relative Centrifugal Force: 2,000g
• Capacity: 6 x 1.5ml
• Operating Temperature: Ambient
• Weight: 494g
• Dimensions: 120mm H x 130mm W x 137mm D
• Electrical: 110V;50/60Hz , 220V:50/60Hz

Small - The mini-centrifuge can easily squeeze onto a crowded countertop.

Safe - Turn centrifuge on and off without opening the lid using an independent switch.

Simple - A pop-open latch system and transparent lid allow you to monitor the sample while it spins. Polished ABS finish quickly wipes clean. Internal mini-transformer eliminates cumbersome adapters.

Quiet - The low-durometer foot grip and fiberglass-reinforced carbonate rotor assure sure-footed, noise-free operation.

Convenient - The 6 tube, fixed-angle rotor requires no unlocking, no releasing, just pop the tubes in and out. Included adapters quickly accommodate 0.5 ml tubes.

Slide Dispenser:

Made of stainless steel. Holds up to fifty-four 75 mm x 25 mm slides. Dispenses slides one at a time on down stroke of lever. Keeps slides essentially dust free. Convenient to use. 5" long x 3" wide x 4" deep.

P-80® Grip-it Quick-drying Temporary Assembly Lubricant eases installation of tight-fitting rubber and plastic parts by reducing the force needed for assembly. Once assembly is complete, P-80 Grip-it dries and provides resistance that helps keeps parts in place. P-80 Grip-it can be applied manually or automatically, by dip, brush, or spray techniques. P-80 Grip-it is ideal for insertion of hoses that are pressure-tested immediately after assembly, and in any application that requires a fast-drying lubricant. Typical uses include installation of hoses, grips, o-rings, seals, bushings, gaskets, grommets, and many other rubber and plastic parts.

Comes in packages of 24. Available in 4 ml, 8 ml, 12 ml, and 16 ml capacities.

The LBP310 laboratory microwave oven is a time and power level based microwave that incorporates the exclusive True-To-PowerTM power control system. This power control system allows the user to set the true power level to any value. Specifications - Output power: 800 watts - Required power: 110 volt, 60 Hz. (230 volt, 50Hz available) - Dedicated 15-amp line - Weight : 49 pounds Dimensions: - Outer: 20 1/2" w x 12 1/8" h x 16" d (W/O handle) - Cavity: 13 7/8" w x 8 1/8" h x 14 5/8" d Cavity exhaust airflow 15 cfm, into free air Operating frequency: 2.45 GHz (an internationally regulated ISM frequency)

120 Watts: - Exterior Dimensions: 13" w X 15" h X 11" d - Interior Dimensions: 12" w X 10" h X 10" d - Electrical: 115VAC*, 120 Watts - Operating Range: Ambient +2°C to 62°C 235 Watts: - Exterior Dimensions: 19" w X 21" h X 13" d - Interior Dimensions: 18" w X 16" h X 12" d - Electrical: 115VAC*, 235 Watts - Operating Range: Ambient +2°C to 62°C *All incubators are available in 230VAC at no additional charge. Please let us know at the time of your order.

Paper Photographic Storage Envelopes With Printed Headings for Recording Data