Laboratory Supplies - Disposables, Storage, Safety Aids & More

Our new mini-centrifuge is the perfect answer for quick spin-downs from tubewalls and caps, HPLC preparations, cell separations and micro-filtration tubes. The tiny footprint and quiet operation makes it perfect for desktop use or quick transport between countertops. A great convenience and a superb value!

Specifications:

• rpm: 6,000
• Relative Centrifugal Force: 2,000g
• Capacity: 6 x 1.5ml
• Operating Temperature: Ambient
• Weight: 494g
• Dimensions: 120mm H x 130mm W x 137mm D
• Electrical: 110V;50/60Hz , 220V:50/60Hz

Small - The mini-centrifuge can easily squeeze onto a crowded countertop.

Safe - Turn centrifuge on and off without opening the lid using an independent switch.

Simple - A pop-open latch system and transparent lid allow you to monitor the sample while it spins. Polished ABS finish quickly wipes clean. Internal mini-transformer eliminates cumbersome adapters.

Quiet - The low-durometer foot grip and fiberglass-reinforced carbonate rotor assure sure-footed, noise-free operation.

Convenient - The 6 tube, fixed-angle rotor requires no unlocking, no releasing, just pop the tubes in and out. Included adapters quickly accommodate 0.5 ml tubes.

Learn More

Transfer sheet. Learn More

Transfer sheet. Learn More

Slide Dispenser:

Made of stainless steel. Holds up to fifty-four 75 mm x 25 mm slides. Dispenses slides one at a time on down stroke of lever. Keeps slides essentially dust free. Convenient to use. 5" long x 3" wide x 4" deep.

Learn More

Transfer sheet. Learn More

Transfer sheet. Learn More

P-80® Grip-it Quick-drying Temporary Assembly Lubricant eases installation of tight-fitting rubber and plastic parts by reducing the force needed for assembly. Once assembly is complete, P-80 Grip-it dries and provides resistance that helps keeps parts in place. P-80 Grip-it can be applied manually or automatically, by dip, brush, or spray techniques. P-80 Grip-it is ideal for insertion of hoses that are pressure-tested immediately after assembly, and in any application that requires a fast-drying lubricant. Typical uses include installation of hoses, grips, o-rings, seals, bushings, gaskets, grommets, and many other rubber and plastic parts. Learn More

P-80® Emulsion for Incidental Food Contact (IFC) is a temporary assembly lubricant that eases installation of tight-fitting rubber and plastic parts by reducing the force needed for assembly. Once assembly is complete, the lubricant dries and the part returns to its original condition. P-80 Emulsion IFC can be applied manually or automatically, by dip, brush, or spray techniques. Use P-80 Emulsion IFC in incidental food contact applications when a thin film of lubricant is desired.

P-80 Emulsion IFC Temporary Assembly Lubricant is used to install pump seals, hoses, o-rings, bushings, gaskets, grommets, grips, and many other rubber and plastic parts.

P-80 Emulsion IFC meets FDA regulation 21 CFR 178.3570 and is NSF-Registered as an H1 lubricant.

Typical viscosity of P-80 Emulsion IFC: 120 cps at 25° C.

Learn More

Comes in packages of 12. 12 ml or 28 ml capacity available. Learn More