All Products

Diameter is 3.05mm and thickness is 0.7mil. Packaged 100/vial. Copper Gilder grids have been plated with palladium. This treatment provides extra strength and eliminates the tarnishing typically found on pure copper grids. Learn More

P-80® THIX Temporary Assembly Lubricant gel eases installation of tight-fitting rubber and plastic parts by reducing the force needed for assembly. Once assembly is complete, the lubricant dries and the part returns to its original condition. P-80 THIX is especially useful in overhead and vertical assembly operations because it remains where it is applied without dripping. P-80 THIX thins out under pressure so it can be used in automated systems or applied manually by dip, brush, or spray techniques. P-80 THIX Temporary Assembly Lubricant is used to install hoses, o-rings, seals, bushings, gaskets, grommets, grips, and many other rubber and plastic parts. Use P-80 THIX when a thick coating of lubricant is needed, when it is important that the lubricant stay where it is applied, and/or when a prolonged drying time is desired. Typical viscosity: 7,500 cps at 25° C Learn More

Includes two 9/16ID x 3/4"OD x 3/32" thick O-rings, two PTFE washers, two 1 7/8"ID x 1 11/16"OD x 3/32" thick O-rings, two ball valve gaskets and one tube Apiezon L vacuum grease. Learn More

We have decided to discontinue the manufacture of all Ladd Vacuum Evaporators. However, we will continue to sell most parts and accessories for them. Please call us at (802) 658-4961 if you require a part or if you have any questions. 

 

Applications Include:

- Preparation of uniform high purity ultra thin carbon support films

- Carbon replication

- Aperture and microhole cleaning

- SEM sample coating

- TEM grid support films

- Noble metal deposition

- Chromium coating

- Silicon monoxide coating

Learn More

We have decided to discontinue the manufacture of all Ladd Vacuum Evaporators. However, we will continue to sell most parts and accessories for them. Please call us at (802) 658-4961 if you require a part or if you have any questions. 

 

Applications Include:

- Preparation of uniform high purity ultra thin carbon support films

- Carbon replication

- Aperture and microhole cleaning

- SEM sample coating

- TEM grid support films

- Noble metal deposition

- Chromium coating

- Silicon monoxide coating

 

Key advantages of a turbo pump over a diffusion pump:
1.  Quicker pump down. From a cold start to high vacuum in less than 3 minutes.
2.  Cleaner system - No oil vapors.
3.  Better, faster vacuum.
4.  Air cooled. Water is not required for cooling a turbo pump.

Learn More

Learn More

We have decided to discontinue the manufacture of all Ladd Vacuum Evaporators. However, we will continue to sell most parts and accessories for them. Please call us at (802) 658-4961 if you require a part or if you have any questions. 

 

Key advantages of a turbo pump over a diffusion pump:
1.  Quicker pump down. From a cold start to high vacuum
      in less than 3 minutes.
2.  Cleaner system - No oil vapors.
3.  Better, faster vacuum.
4.  Air cooled. Water is not required for cooling a turbo pump.

Learn More

Learn More

Learn More