Vacuum Equipment Including Sputtering Targets & Desiccator Cabinets

• Small footprint with 13% more interior volume than typical desiccator domes
• Glass transparent, shatter resistant polycarbonate upper section offers unobstructed viewing of contents
• Polypropylene lower section has excellent chemical resistance and can be used with incandescent crucibles supported on porcelain plate
• Polypropylene stopcock with a PTFE plug controls airflow to gently release vacuum
• Stores full vacuum 29.9" Hg (759mm) at room temperature for 24 hours without need for vacuum grease
• Classic Dome Design Desiccators with and without Vacuum Ports

Learn More

One quart replacement fluid for Ladd Chiller. Very low viscosity. Chemically equivalent to Dow-Corning 200 Fluid, 10 centistokes Learn More

Exceptionally high quality oil for direct drive or belt driven vacuum pumps. Learn More

Santovac 5 - Diffusion Pump Oil. A Polyphenyl Ether. Learn More

Distilled hydrocarbon. Ultimate pressure 5 x 10-8 torr at 25o C. Convoil 20 is also ideal for mechanical pumps. It has lower sludge, exhibits less degradation and provides 5 to 10 times the life of other oils. Learn More

Equivalent to Dow Corning #704 Fluid. Vapor pressure at 25oC is 8.2 x 10-8 torr. Boiling point at 0.06 torr is 220^o C.Tetramethyl tetraphenyl trisiloxane.

Learn More

Manufactured to prevent the cut ends from unravelling. 2 mm diameter. 1 meter long.

 

Carbon fiber and thread are used in vacuum evaporators or sputter coaters with a fiber attachment. Approximately 20 Amps is required to evaporate. No sparking of carbon particles. Spectrographically pure.

Learn More

Composed of 2 threads so can be unthreaded to reduce the diameter. 1 mm diameter. 3.5 meters long.

 

Carbon fiber and thread are used in vacuum evaporators or sputter coaters with a fiber attachment. Approximately 20 Amps is required to evaporate. No sparking of carbon particles. Spectrographically pure.

Learn More

The Ladd / Hummer™ 6.2 performs sputter coating, a cold process in which ions impacting a metal source dislodge metal atoms. The atoms disperse throughout the process chamber to uniformly coat irregularly shaped specimens without thermal damage. Sputter coating produces high quality coatings whose thickness is repeatable and easily controlled. Cold, fast sputter rates require less time, giving you more time for microscope examinations.

The Carbon Evaporation Accessory and the Digital Thickness Monitors must be ordered at the same time as the sputter coater and are only available for newly purchased sputter coaters.

Please Note!! The SC6.2TR comes with a 6 inch diameter chamber and with a tilting rotary stage already installed. The chamber for all other 6.2 models has a 4" diameter. 

Learn More