Laboratory Supplies - Disposables, Storage, Safety Aids & More

Glass flash with a side arm for boiling.

Glass Column Condenser.

To support still. Extra heavy stand plus clamps and ring.

Portable vacuum base easily attaches to smooth, non-porous surfaces such as Formica, porcelain or stainless steel. Mounting lever attaches and releases heavy duty suction pad - moistening the pad increases its grip. Holds all Standard PanaVise heads with same variable load control knob allowing movement as in Standard PanaVise Base (sku: 11492).

Used with L03090 or L03067 and clamps the small pyrex rods into the L590. The clamp is anodized aluminum and squeezes against the pyrex rod, holding it in place. Included at no charge with the purchase of the BiPod Polisher.

Outside dimensions: 17 3/4" high x 19 3/4" wide x 19 1/2" deep. Adjustable shelf. Magnetic door gasket. Adjustable thermostat. Hermetically sealed copressor. UL approved. Small freezer compartment. Operates on 115 VAC.

The SEM stub mount is designed specifically for mounting specimens for SEM polishing. It fits directly into the stage of most standard SEM stages and eliminates the need for remounting the specimen prior to SEM observation. Included at no charge with the purchase of the BiPod Polisher.

The LEBSD (Electron Backscatter Diffraction) Specimen Polishing Kit is based on the Model L150 micrometer controlled lapping fixture. Two mounting blocks are included to hold a 1/8" diameter pin SEM mount for plan view preparation of a Tripod Polisher SEM mount for XSEM preparation. The stubs are secured into the block with a set screw prior to loading into the lapping fixture. The kit includes a SampleSaver FIB storage container and two tier locking rack, and pin adapters for holding the L150 mounts. A pre-tilt EBSD specimen stage is included with three height segments. The low profile mount fits most SEM load locks and can be stored in the Sample Saver without removal from the pre-tilt holder. Special Features A relatively simple and inexpensive method for mechanically polishing and mounting EBSD specimens on an SEM stub, allowing quick transfer without dismounting a prepared sample. Pre-Tilt EBSD specimen stage keeps sample at a fixed angle of 70o or the complementary angle of 20o in the chamber. The process utilizes conventional, easily available, precision abrasives and is compatible with other sample preparation equipment and consumables. The Model L150 Lapping Fixture can be utilized for other routine parallel and angled polishing processes without modification. Up to 1.25" diameter mounting blocks are available. A low force Model L150L lapping fixture is available as an option. Complete process recipes, consumable supplies, and other accessories are available and include hand lapping tray, lapping and polishing machines, hot plate/cooling tray and sample mounting devices.

Same mechanical features as Standard PanaVise Head, except that stem is attached to rear of head to permit positioning work closer to the work bench. Heavy-duty steel jaws may be interchanged with optional accessory nylon jaws. By combining with optional Low-Profile Base, the work piece can be swung out and away from the work bench for clearance.

3" diameter top plate. Cabinet dimensions 7 1/4" x 5 1/2" x 4 3/4". Power requirements 50 watts. This unit uses the most efficient solid state thermoelectric modules yet developed. DC power is supplied to these high powered modules to control temperatures between +25^o C and -20^o C depending on the set point required. All units may use air cooling with built-in fan, or tap water cooling as the heat exchanger. Equilibrium is reached in 2-3 minutes. Lightweight, portable. Has been used successfully in recrystallizations, freezing point determinations, and temperature control for physical measurements.